Questions & Answers for: Dodge speed of light

...light on my dash stayed on. Also my speedometer was not working at all from 0 to 20 miles per hour (mph). It appears to be reading properly from 20 mph and faster. The transmission seems to be ...

...LIGHT ARE ON . Change the speed sensor in the top of the rear differential I replaced the speed sensor and my check engine light went off but my parking light and abs light remained on. Also, the ...

speed sensor ($33) and then reset the CHECK ENGINE light by disconnecting the positive battery cable for a couple of minutes. EVERYTHING then worked. Replace rear differential speed sensor as follows:

...light to come on and the speedometer to act funny. There are two speed sensors...one in the transmission and the one on the differential. The second one is probably the problem. a bad speed sensor on ...

...light came on! All at once. Have not done any troubleshooting yet. Any Ideas where to start? JW sounds like wiring to rear speed sensor in rear differential or speed sensor itself..check wiring and ...

...light on, autozone says speed sensor code, most likely the one on rear end housing...replaced, still have problem, might it be the other speed sensor on trans??? More then likely transmission speed ...

light remains on because of speed sensor. what is the function of a speed sensor speed sensor tells the pcm how fast the car is going, Also it serves to tell the abs computer that the wheel speeds are

...speed speedometer readings. I have had the same problem. It will cause the BRAKE and ABS lights to light as well as affect the speedo under 35 mph. It is an easy fix, and can be done by a DIYer or a ...

check engine light on.overheats when a/c on at low speeds or idle Does check engine go out at higher speeds?  If not, what is the "CODE" (several parts places will read your codes at no cost ...

...speed, or anything. all fuses are good Suggest 2 basic checks: 1. check engine light on? Some severe codes may also disable cruise control (and traction control, etc.). 2. make sure your break lights ...