...in the right seqwence I need the proper wiring order for a 88 jeep, 4.0, Plug to cap diagram this is the best I could find... ...
location of fuel pump relay I need the location of the fuel pump relay for 1989 jeep comanche should be under the hood on the drivers side
...Jeep comanache. I have removed the steering wheel and put in a new egnition switch. The blinker arm fell off and I am not sure how to put back together properly. Hope you can help. If it is the old ...
...signal issues 87 Jeep Comanche, turn signal lights up brightly, but won't pulse. Hazard lights, however, seem to work correctly. You will find that there are two flasher units on the fuse panel. Turn ...
...Jeep Commanche Pioneer.The signal lights in front and rear turn on when switched, but they don't flash. I already replaced the bulbs and thermal flasher, but the problem remains. Change the signal ...
Question about 1988 Comanche
...signal lever. what can i do? Check you fuse box, your flase relay, light bubs, and finally the switch itself Hey guys I had the similar issue, but when I would hit my brakes the passenger side tail ...
Jeep Commanche w air that must have an older wiring harness in it. The cooling fan relay has been cut off but I have a newer relay harness. I need to cross over the new relay harness to the old wiring
...inside the main relay panel on your Jeep. However, the exact location of the relay inside the relay panel may vary depending on the year and model of your Jeep. ...
jeep Comanche, im not getting power to the fuel pump,and ive followed the wire as far as I could,also,the pump is good i ran power directly to it,fuses are good too ,and im not sure which relay is the
relay getting power and a ground signal from the computer ? which engine, Nat.? 2.5L or 4.0L? in the XJ/MJ pickup.
1986 is the first, AMC EFI, used, in Jeeps.
this is the RENIX system (French
Usually answered in minutes!
29 Questions
23 Questions
6 Questions
104 Questions
95 Questions