...some help. Note sounds like a small chevy that is 180 degrees of. Make sure timing marks are both pointing to 12 o'clock then set distributor on #1,,, I think firing order is 1342 , its been
...set timing" connector. This is a single wire sealed connector that has a tan with black striped lead. The location of the "set timing" connector with a Powertrain Control Module (PCM) controller is ...
...set ignition timing, ensure that engine is at operating temperature, (190 degrees or above), bypass EST (electronic spark timing) by unplugging the single tan wire with a black stripe from the ...
timing the engine was loose. I repared the connection and the idle improved and the light went off. After driving the truck 5 miles or so approching a stop light in 5th gear under no accelerration the
...set the timing do the following , with the rotor pointing to number one rotate the distributer against the rotation of the rotor till the points are closed, make sure the crank is at tdc then rotate ...
Question about 1996 Chevy Cavalier Z24 GM Style Black Lug Nut Cap Set of 5
engine runs rough at idel and smooths out a little bit as rpms are raised what could be causing this Loose timing chain will do it.
Question about 1995-1997 Chevy 3500 Truck Ignition Starter Alarm Switch
...set the timing on the engine and if it is ok try some higher octane fuel in the engine or mix some low and high octane gas about 50/50 and see if that helps the condition. If not move the engine ...
Question about 1998 Chevy 3500 Pickup Truck All Chrome Grille Grill
...set the engine time you would: 1. Mark the timing slot on the balancer with white chalk. 2, Loosen the bolt on the dist. just enough so you can move the dist. 3. Remove the single wire coming out of ...
Question about 1998 Chevy 3500 Pickup Truck All Chrome Grille Grill
...set ignition timing 88-95 GM fullsize truck Silverado ... ? 10:56 https://www.youtube.com/watch?v=y5NuS-G-cKI Dec 5, 2013 - Uploaded by Ghetto Wagon I thought the parts when the engine was running ...
... Timing Chain Lever Retaining Bolts 10 Nm 7.4 lb ft · Engine Mechanical Specifications · l No. 4 23-23.021 mm 0.9055-0.9063 in. Rating: 5 · ?1 vote ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions