...sedona will not open The cable leading from the handle to the mechanism is stretched or if it has a rod it has come unhooked. Or it could be a bad mechanism or somthing caught in it from inside as if ...
...like the door latch mechanism is worn out. The door latch mechanism for your door is operated by rods, from the inside door handle, and the outside door handle. It is highly unlikely, (Though not ...
...turn but it doesn't unlock. why is that There is a good possibilty that the key tumbler mechanism "rod" has become disconnected to the door control mechanism. These rod connections are plastic and ...
...what could this b?? You will need to remove the inside door trim panel and check the three (3) rods and plastic connectors that connect: (a) the inside door handle to the door mechanism (b) the ...
...mechanic that I need to replace 3 of the 4 tie rods. Might as as well replace all 4, but how hard is it to do myself? I am very mechanically inclined and would like some advice. Thanks - Sam You will ...
...whats wrong with the locking mechanism. What could be the problem? This is almost always because a rod and clip have come apart.The rods that go from the handles to the mechanism are just under
Question about Pegasus Clear Round Glass Vessel Sink With Drain Kit
ll need to access back side of sink bowl and locate drain mechanism, most likely either the plunger rod has loosened up from clevis rod or clevis rod is positioned to far in towards drain line causing
Question about 2001 Mountaineer
where can I find a diagram for the door lock mechanism for a 2001 mercury mountaineer? The rod that connects to the latch mechanism to the key lock mechanism came off the key mechanism the clip is ...
Question about 2001 Mountaineer
Where can I find a skematic for the door lock mechanism on a 2001 mercury mountaineer The rod that connects to the latch mechanism to the key lock mechanism came off the key mechanism the clip is ...
Question about 2001 Mountaineer
When removing mechanical fuel pump and going to electrical. Do you remove the rod that operates the old mechanical pump from the block? You haven't said what type of engine you have. However my ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions