main bearing and connecting rod bearing bolts. Tighten the main bearing bolts in two stages. Stage 1: 25 Nm. Stage 2: 60 degrees. Tighten the connecting rod bearing bolts in two stages. Stage 1: 35 Nm
Question about 2000 Rodeo
...the limit, replace the rod bearing as a set. Standard: 0.019 mm - 0.043 mm (0.0007 inch - 0.0017 inch) Limit: 0.08 mm (0.003 inch) Clean the plastigage from the bearings and the crankshaft
Question about 1989 Silverado 2500
...but i need to find out how much torque the bearings to see if there bad or i need to replace them Rods 45 mains 75...You have to look at the bearings and also use plasti-gage to check clearances
...mechanical oil pressure gauge on the motor it selef check your rod bearings and main bearings did you prim the new oil pump? or the cam bearings could of gone out most of the time its the rod or ...
...main bearing as outlined in this section. After the bearing has been fitted, apply a light coat of engine oil to the journal and bearings. Install the bearing cap in their original locations . (refer ...
rod barrings Main bearings at 80 foot lbs. rod bearings at 30 foot pounds. Make sure you check clearances with plastigage before you button it up and light it. Anything out of clearance may require an
...MAX (0.02) Crankshaft Main Bearing Journal Taper mm (Inch) 0.020 (0.0007) Crankshaft Main Bearing Journal Runout mm (Inch) 0.05 (0.002) Crankshaft Connecting Rod Journal Taper mm (Inch) 0.015
Question about 1998 F150 Regular Cab
...ROD BEARING BOLTS 19 - 24 FT LBS TORQUE SPEC FOR MAIN BEARING BOLTS 60 - 70 FT LBS, CRANKSHAFT PULLEY BOLT 85 - 100 FT LBS. MAIN BEARING OIL CLEARANCE .0005 - .0022 CONNECTING ROD OIL ...
Question about 2004 Silverado
rod and main bearings and i still have somewhat low oil pressure when driving about20 pounds and at idle it has 5 pounds.the oil screan was stopped up and was cleaned.replaced the oil pump and rod and
Question about 2004 Silverado
...,TRY RINGING CUMMINGS 03 9765 3222 or 03 9360 0800. Good luck....Cummings 6B, 6BT, 6BTA Main Bearing bolts 176 Nm, 130 lb.ft. Con rod 102 Nm, 74 lb.ft. Cylinder head bolts 126 Nm 93 lb.ft ...... ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions