Questions & Answers for: rod bolts

...rod bearing bolts. Tighten the main bearing bolts in two stages. Stage 1: 25 Nm. Stage 2: 60 degrees. Tighten the connecting rod bearing bolts in two stages. Stage 1: 35 Nm. Stage 2: 90

...bolts 18 ft lbs..the 6.0 engine rod bearings torque is 15 ft lbs plus 85 degrees.the main bearings torque is inner bolt 1st pass 15 ft lbs .final pass plus 80 degrees. outer bolts .1st pass 15 ft lbs ...

how to repaire inner tie rod bushings you need to get it out. get on the engine and go to the back at the fire wall look for the bolt that hold the tie rod there should be a lock washer which is bent ...

...rod cap bolts. 2. Install and alternately tighten the 2 connecting rod cap bolts in several passes. Torque: 1ZZ-FE: 20 Nm (204 kgf-cm, 15 ft. lbs.) 2ZZ-GE: 30 Nm (306 kgf-cm, 22 ft. lbs.) If any of ...

...Rod bolts considered for reuse should be free of nicks and burrs and allow easily threading the bolt or nut with one's fingers. To further consider the rod bolts for a 1.6L engine, measure the bolt ...

...rod cap bolts does not meet the torque specification, replace the connecting rod cap bolts.3. Retighten the cap bolts by 90 more4. Check that the crankshaft turns

rod bracket on such an angle that it snaps of. Removal... Loosen 10mm hex key tension bolt at front of tensioner and remove belt. Once the belt is off, remove water pump pulley. Powerstering pump also

...bolt fell out upper in 2007 GMC Envoy bolt on upper ball joint driver front end fell out. had tie rod replaced approx 3000 miles prior, plus alignment...then brakes checked one week before bolt

Rod bolts torque specs 6.0 l engine in chevy 2004 Connecting Rod Bolts - First Pass 20 N·m 15 lb ft Connecting Rod Bolts - Final Pass 85 degrees of bolt head rotation. I want to know the final torque ...

...Rod Bolts Step1 = 51 lb.ft ... main bearing cap bolts, connecting rod cap ... Workshop Manual Hino J08C No.1 ' PDF Scribd https://www.scribd.com > document > WORKSHOP-MA... ... SPECIFICATIONS DIESEL ...