...rod bearing clearance, main bearing clearance,crankshaft run out, connecting rod journal diameter and maximum allowable taper/out of round for it. Main bearing journal diameter and Maximum allowable ...
...rod cap nuts. (c) Using a plastic−faced hammer, lightly tap the con necting rod bolts and lift off the connecting rod cap. HINT: Keep the lower bearing inserted with the con necting rod cap.
Question about 2000 Rodeo
...the limit, replace the rod bearing as a set. Standard: 0.019 mm - 0.043 mm (0.0007 inch - 0.0017 inch) Limit: 0.08 mm (0.003 inch) Clean the plastigage from the bearings and the crankshaft
rod bearings at 30 foot pounds. Make sure you check clearances with plastigage before you button it up and light it. Anything out of clearance may require an over or undersized bearing. Also, on final
Question about 2000 Rodeo
rod bearing caps. i am replaceing all the bearings so i would also like the know the clearance between the bearing and the crankshaft cause i am using plastigauge. TORQUE SPEC FOR ROD BEARING BOLTS 19
....001 and .003 and can be measured with a set of feeler guages. this is not a bearing clearance, but a clearance between the rod and the crankshaft. Bearing clearance can be measured with plasti
Question about 2001 9-3
...rod and main bearing torque specs for a 96 chevy S-10 2.2? 1996 , S-10, 2.2 The torque spec for the main bearing caps on a 2.2 are 105 nm or 77 ft lbs all. But you know if your doing the crank there ...
...rod to crank with the new standard size bearing and had to move to a larger plastigage as the plastiage hardly compressed. I'm guessing the clearance is about .152mm. The Service Manual says the ...
Question about 1994 Legend
Rod Cap - Bolts .............. 27 +1/4 Nm Turn (20 +1/4 Turn ft. lbs.)CONNECTING RODS Bearing Clearance ........................ 0.024-0.064 mm (0.001-0.0026 in.) Side Clearance ......................
Question about 1994 Legend
...,TRY RINGING CUMMINGS 03 9765 3222 or 03 9360 0800. Good luck....Cummings 6B, 6BT, 6BTA Main Bearing bolts 176 Nm, 130 lb.ft. Con rod 102 Nm, 74 lb.ft. Cylinder head bolts 126 Nm 93 lb.ft ...... ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions