Questions & Answers for: replace ignition lock cylinder 2006

ignition and won't come out but can still drive and start the vehicle and I have to diconnect the battery to kill power to the dash panel. This has had this problem before and the shifter was replaced

Ad

Question about 2002 Grand Prix

5 Answers

replace the ignition switch (expensive) or bypass the module (easy and inexpensive)-I have done lots of these, requires about 15 cents worth of parts and can be done in 1/2 hour. If the headlights are

Ad

Question about 2002 Grand Prix

4 Answers

...or actually the ignition key cylinder but keep the door lock key...after you change the key cylinder lock the doors with the key then unlock the doors with the key and it should start and run ...

Question about 2002 Grand Prix

2 Answers

...ignition switch. Try turning key to run (do not crank) leave key on for 10 minutes, the security light should be flashing. When it stops flashing or goes solid (after 10 min relearn) try to start ...

...Ignition cylinder problem? It's when the security light starts flashing that the infamous "chip" in the key becomes a nightmare to many. Gradually the car begins not cranking anymore or if it cranks ...

...ignition key is not used in order to start the vehicle. The mechanical key, in normal operation, will turn the passlock™ lock cylinder. The passlock™ sensor will relay the passlock™ data to the body ...

Question about 1998 Blazer

1 Answer

...ignition switch happen and locked my key, wheel, and shifter into place until my battery got charged.... Any suggestions?? It's when the security light starts flashing that the infamous "chip" in the ...

Question about 1998 Blazer

1 Answer

...ignition cylinder broke or the pins that read your key are jamming it. Try turning it back with the key out. Or try turning it back with the car in nuetral. Remember to set parking break in nuetral. ...

Question about 1998 Blazer

2 Answers

replace and can only be worked on by "authorized" GM service men with out voiding warrenty. Most garages dont even touch them and if they do, they will sell you every part they can before "fixing" the

Question about 2000 Astro

3 Answers

IGNITION IS TURN ON AND OFF FOR THE SAME NUMBER OF TIMES. CHECK FUEL PRESSURE SHOULD BE 58 - 64 PSI. IF YOU HAVE ZERO FUEL PRESSURE OR LOW FUEL PRESSURE.AND FUEL FILTER BEEN CHANGED YOU HAVE FUEL PUMP

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...