...brake system light comes on periodically but goes out after a few seconds. I recently had my rotors, pads and rear hardware on back brakes replaced. I would recomend to check the wheel ...
...able to get the caliper back over the rotor with the new pads in place. You will have to replace the rotors if they have been damaged by the worn out brake pads. Hope this helps you with your ...
Question about 1999 Blazer
...replace them. The second cause is also related to the brake pads. It usually happens after new brakes have been put on without a anti squeak solution being applied to the back of the pads. Although ...
...brake fluid and check that is not leaking if it is you might have to replace it, or purchase a seal kit for it hi. sounds like there is air in the hydraulic system. you have to bleed the whole system ...
...brake pads what could be the problem? check the sensor wiring and mounting area for clean surface. you have been given the wrong rotors, The parts store is responsible for making sure they are ...
Replace the brake pads and rotors since the rotors are not that expansive, might as well replace them also. Good luck and stay safe, thank you for using fixya. Just an FYI... Check E-BAY for the brake
...brake hose, caliper, pads on left side/ replaced caliper and pads on right. brakes froze up. Then I replaced rotor, caliper, pads on left/ replaced rotor and pads on right On both occasions they ...
Question about 1996 Blazer
...brake pedal groans and depresses a little at the end of braking to stop only. All brakes pads, rotors,calipers were replaced 5000 miles previous to this problem. Lights dim for a moment when this ...
Question about 1999 Blazer
...brake lines, calipers, pads, rotors and even the master cylinder has been replaced on a '99 chevy blazer. The dilemma is that the system bleeds and pressurizes fine with the engine off. ...
Question about 1999 Blazer
...brake lines, calipers, pads, rotors and even the master cylinder has been replaced on a '99 chevy blazer. The dilemma is that the system bleeds and pressurizes fine with the engine off. However, ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions