...front bumper at Left hand side. I can see the hole for the sensor, but no sensor. Purchased a sensor but there does not appear to be any wiring harness to connect it up to. Haynes show a 2 pin socket ...
...front bumper Remove and re-fit front bumper of mercedes C180 W202 for repair work The bumper is secured using four 13mm nuts. a) Open the bonnet and look for one 13mm nut on the lower inside of each ...
...front bumper(held on by 5-6 eight mm headed sheet metal screws). Unplug the wire to the lamp and remove the four screws holding the fog lamp on.(4 Torx screws). You can't get a screwdriver into this ...
...rear there are 4 bolts inside the bolt remove these and it slides off along some rubbers sliders the front is a bit more faffy as you have to get under the car removing bolts and shields to get at ...
Usually answered in minutes!
630 Questions
615 Questions
474 Questions
420 Questions
413 Questions