...the front of your vehilce on the passenger side up behind the bumper can be accessed from the under side by removing the front cover,most times I have seen pipes coming off and filling with
...the skid plate under the front bumper and you should be able to see where its leaking from,a water pump will be a steady drip while its running usually but a expansion plug will pour out very ...
...front bumper get some pliers and locate the hood latch cable and pull on it. Or if the handle is broken from inside just use pliers and use those to just pull the wire towards you. That's how I do ...
...front bumper on the passenger side. It is about the size of a baseball and has two hoses going into it. I would suggest you replace it yourself as it would cost you about $360.00 if you were to go ...
Front or rear, I am guessing it is the rear as they tend to get the most abuse and or rust! Start by removing the plastic step guard on the top of the bumper (use a flat ply bar) you will see the four
front bumper. Its hidden up there, you will likely have to remove plastic cover or carefully pull down on it to see it. It will have an electrical connector going to it as well as rubber hose. Here is
...front bumper look in the plastic skid plate there should be a little door that opens with a flat screwdriver S-10 Blazer early models had a remote mount on the drivers side of the engine compartment ...
how to remove front bumper 1999 blazer front crome bumper look behind bumper you'll see nuts near bumper brackets
Usually answered in minutes!
2,307 Questions
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions
