Questions & Answers for: remove transfer case

Question about 1999 Silverado 1500

1 Answer

...Remove transfer case bolts from trans. Remove mount nuts from transfer case bolts. Remove bell housing bolts from motor to trans. Remove bolts from crossover support for transfer case mount from the ...

Ad

...transfer case. Remove the damper from the transfer case, if so equipped. On electronic shift models, remove the wire connector from the feed wire harness at the rear of the transfer case. Be sure to ...

Ad

...transfer case (behind the transmission). Remove the drain plug from the bottom. Wipe the area clean and replace the drain plug. Add lubricant with a suction gun or squeeze bulb. Conventional transfer ...

...and rear drive shafts and remove the bolts from the transfer case around the transmission the transfer case will then slide backwards and off of the transmission i need to replace transfer case ...

Question about 1993 Tracker

1 Answer

...remove the transfer case shift lever. Raise and support the vehicle safely. Drain the oil from the transfer case. Matchmark and remove the driveshafts from the transfer case assembly. Not all of the ...

Question about 1993 Tracker

1 Answer

...transfer case. Remove five bolts connecting the transfer case to the transmission, this step will cause some transmission fluid to leak from the shaft housing (approx. half a litre) so place a drain ...

Question about 2000 Bravada

2 Answers

...remove a transfer case The transfer case problem is very much noticed by other Oldsmobile bravda users. Oldsmobile technical service bulletins (TSBs) report that second and third generation Bravada ...

...remove transfer case from 2002 tahoe Disconnect the ground cable from the negative battery terminal, by using a wrench to loosen the retaining bolt and pulling the clamp off the terminal.2 Raise the ...

...Remove the transfer case shifter rod. Using needle-nose pliers, remove the clip that connects the shifter rod to the transfer case. Slide the rod away from the transfer case. 8 Position a floor jack ...

Question about 2000 Bravada

2 Answers

remove transfer case mount bolts raise transmission and transfer case with Jack under transfer case remove the cross member from the frame very slowly let the jack down about three or four inches with

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...