stub axle. Remove the bearing retainer. The press out the bearing. Do not use a hammer instead of a press, because it will damage the bearing. But you can use the weight of the vehicle like a press if
...stub axle? The simple answer is YES. You will need to remove brake drum / hub and inner and outer wheel bearings. This allows access to the retaining bolts. Although a little tricky___You should now ...
...remove the nut from the stub axle,pull the wheel speed sensor out of the wheel bearing housing, if it is rusty, spray some wd40 on it and leave for a while, if that does not still make it come out, ...
...remove the nut.pull hub/brake drum from the stub axle.Drift out old bearings.Clean out hub.Fit both new bearing outers,and inside inner bearing and new seal .Grease and refit hub to cleaned stub ...
car makes a dull but obvious clicking noise when coasting only...coming from the front left-ish of the car. the clicking goes away as soon as the gas pedal is pressed and comes back as soon as it is ...
Question about 1997 Jetta
...out of the transaxle of my 97 vw jetta removing the trans to put new clutch in axle unbolts and is removed but there is a stub there that is against the flywheel how does that stub come
Usually answered in minutes!
1,967 Questions
1,322 Questions
1,226 Questions
1,072 Questions
1,150 Questions