...remove it, keep in mind that it was installed at the factory, so removal is just the reversal. Look for a swivel connector at one end of tube (or both ends). This swivel connector is identified by a ...
...stub bolt and has a plastic block that holds the transmission lines that run to the transmission cooler up front. I can't figure out how to remove that bolt without destroying the plastic block use a ...
remove this line from the radiator without harming the line. There is a short stub line coming from the radiator that joins the rubber line to the radiator. squeeze the tabs on the plastic part on the
...stub..They take a bit of time to remove but to get them out you need to remove the hub bearing first. I suggest you get a chiltons or haynes manual to guide you through the process. If you run into a ...
...remove 1996 Jeep Cherokee wiper arm so it can be repositioned on the windshield. If you look where the arm connects to the shaft stub, you will see a small stainless steel tab that swings out. That ...
...remove 1996 Jeep Cherokee wiper arm so it can be repositioned on the windshield. At the base of the arm where it attaches to the drive stub, you should see a "L" tab made of stainless steel. that tab ...
My wipers just stopped working. I have no idea where to find the motor for them. Wiper motor is under the cowl that the stubs for the arms go through. Remove the arms and the cowl and you are there!
...remove hub assembly. Pull the axle shaft out through the opening left by the hub bearing. Cut off the old boot and clamps. Hold axle shaft and tap joint and axle stub off of shaft with a hammer. ...
Usually answered in minutes!
284 Questions
229 Questions
170 Questions
130 Questions
106 Questions