...remove the dash board the steering column needs to be dropped down or better yet also removed from the car. In addition to these two items being removed, the evaporator box in the engine compartment ...
95 f-250 right front stub shaft removal How do I pull the stub shaft from the differential for u-joint replacement on my 95 f-250 4x4 with a 4600lb axle. My old ford had a retaining ring that un ...
...remove it first, of course. Any suggestions are greatly appreciated. Thanks! should be a clip release at bottom on stub. but, you can take a few sheets of newspaper and Mask off window and leave it ...
...remove fully and then wack the end of the stub axle where the track rod end goes through .One good wack with a 1kg hammer will do it on the end of the steering /stub axle shaft without damaging ...
...transmission and inboard CV stub, and gently pry outward in a couple places, until the axle pops out. Place a drain pan under the inboard stub, and remove it. Installation is the reverse of
Question about 2002 F250 Super Duty SuperCab
...and it connects the motor to the stubs under the windshield. Most of the time the wiper motor is removed and it gives you enough room to slip the connectors together. The clip can be installed on ...
Question about 2002 F250 Super Duty SuperCab
where are the wheel sensors located on the 03 navigator on the inside bottom of the stub axle. You do not need to remove the wheel to see them, just follow the wires from the chassis
...Remove the front wheel driveshaft and joint assembly from the vehicle. To install: Do not reuse the retainer circlip. A new circlip must be installed each time the inboard CV-joint stub shaft is ...
Question about 1998 Windstar
...in dash ashtray the problem I have is I've been unable to remove it to clean out the ashes from my wife's cigs. pull it all the way out then press down on the stub out tab and pull it out all the ...
Ford Festiva rear stub axle removal. I've removed the brake drum, the locking nuts that tighten the bolts holding the stub axle to the backing plate. The bolts that go through the stub axle mounting ...
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,347 Questions
2,636 Questions