Questions & Answers for: remove the pulley

...remove the pulley you need to unwind the spring to be safe. Otherwise it will spring out on you. To do this pull about 6" - 12" of the cord out. There should be a slot in the pulley that you can push ...

...pulley. . Remove right engine mounting bracket. Remove No. 2 timing belt cover. . Temporarily install crankshaft pulley with pulle y bolt. Set No. 1 cylinder to TDC on compression stroke. . Loosen ...

...pulley. Remove right inner fender panel to gain access to crankshaft pulley. Remove outer crankshaft pulley attaching bolts, then the outer stiffener/spacer and outer pulley Remove inner ...

...pulley. Remove the crankshaft timing gear , if it can not be removed by hand, use two flat bladed tools to pry it off. Make sure to position shop rags to prevent damages to the components. Remove the ...

pulley. 7. Remove crankshaft pulley. 8. Remove upper and lower timing belt covers. 9. Turn crankshaft so that timing mark on timing belt pulley is aligned with timing mark on engine. 10. Check that "I

...crank pulley ( 5/8ths), remove belt from pulley, remove belt from transaxle pulley, then remove belt from crankshaft, remove belt from idler pulleys and remove from unit. Reinstall in reverse

...remove the pulley assembly from the deck. It is important to be aware of the safety precautions when performing any maintenance on the mower deck. It's also recommended to consult the operator's ...

Remove the power steering pump pulley from the pump noting the following: Use a power steering pump pulley remover. These pullers typically have a ridge that surrounds the collar on the pulley center.

...Remove the crankshaft pulley retaining bolt. Discard the bolt. Remove the special tools. Using the special tools, remove the crankshaft pulley. Collect the locking ring. Remove the special tools from ...

...pulley. Remove the timing belt. To install: Install the timing belt tensioner pulley, move the tensioner to its furthest point and tighten the lockbolt. Install the timing belt onto the pulleys, as ...