...bumper. 1. Raise the car and remove the 4 screws that holds the filter element in place 2. Remove the filter element and clean out the housing that holds the filter. 3. Replace the filter and the 4 ...
...remove the bumper and remove the radiator from the front, first time I did it it took me many hours but with practice, I replaced mine thrice and might have to again, it goes quickly. Is your car an ...
...for a saab 9-5 v6? does it need the bumper to be remove? go to the saabsite for istructions.no you dont if you dont mind ripped up hands...I did it in two hours..definately need heavy duyt
...remove the bumper. It depends on what year your car is, If it's the pre 02 car then inside the boot there are 2 M10 nuts near the tie down eyes, remove these and then pull the bumper tips outwards ...
...wanting to install or replace HEADLAMP on a 2004 saab 9/3 aero. Does the front bumper have to be removed to get to the bottom bolt?? Bumper does not need to be removed but it does need to be ...
...luggage compartment side trim panel on some models, and behind the front bumper on others. Remove the panel or bumper. 3) Undo the 2 retaining bolts, disconnect the wiring plug and remove the
...Saab 9-3 Front Reinforcement Bar can have alook for you tomorrow we have couple of them at work what bar are you actually trying to remove I'm pretty sure the front plastic bumper bar just bolts ...
...for 9.5 rear sensor The parts are on eBay around 100 dollars. If you do the repair then you will have to remove the whole back bumper. There is no way to do this without removing the whole
...tow bar. I believe there are 4 bolts that are accessed in the rear (inside) that need to be removed. The bumper bar should then come off in one piece. A diagram of the exact position of these ...
how to remove front bumper and that´s it :)
Usually answered in minutes!
557 Questions
442 Questions
367 Questions
320 Questions
322 Questions