Questions & Answers for: how to remove bumper

Ad

...hatchback. remove screws from ends of bumper x4, remove bolts from under bumper x2 remove indicaters from bumper x2 remove 10mm head bolts from behind where indicater were x4 lift bumper up and ...

Ad

Question about 2008 9-3

2 Answers

...remove the bumper. It depends on what year your car is, If it's the pre 02 car then inside the boot there are 2 M10 nuts near the tie down eyes, remove these and then pull the bumper tips outwards ...

Ad

...Remove bumper assembly.A.Remove four fasteners and four retaining screws from top of bumper assembly. B.Remove mud flap from bumper assembly. C.Remove two screws from bottom of bumper assembly. ...

...remove a rear bumper cover on a 2007 nissan altima Rear Bumper: Service and Repair REAR BUMPER Removal and Installation REMOVAL 1. Remove the LH and RH rear combination lamps. 2. Remove both the rear ...

...(both sides). 7. Remove the left-hand side bumper retaining nut. 8. Remove the right-hand side bumper retaining nut. 9. Remove the bumper. Installation 1. To install, reverse the removal

...remove the bumper. Have a blanket or carpet on the ground to protect the bumper. 8. Remove metal clips from tabs that connect the upper bumper cover to the lower bumper cover. 9. Drill out pop-rivets ...

Question about 1995 Villager

1 Answer

...front bumper cover from the vehicle. Remove the two front turn signal lamp wire harnesses from the front bumper (17757). Remove the eight front bumper bolts. Remove the front bumper from the

...remove rear bumper 1999 blazer Hi there:Check this Removal Procedure...1. Remove the rear bumper step pads. 2. Remove the license plate lamps. 3. Remove the nuts and the bolts that retain the rear ...

Question about 2004 Sedona

1 Answer

...remove bumper 1. Remove rear combination light assembly. A. Remove two mounting screws. B. Disconnect electrical connector from rear side of light assembly. 2. Remove bumper assembly. A. Remove four ...

Question about 2006 Legacy

1 Answer

...bumper To remove you will have to use air tools as it cuts the time to minutes instead of hours. Remove front tires and unplug lights in fiberglass bumper. Then remove all the screws and remove ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...