Questions & Answers for: rear door wont open 2004

2004 gmc sierra i have a gmc 8 cyl sierra that wont idle it stays running only when gas peddle is held. give it a complete tune up and change the fuel filter if that does fix it then check for a vapor

...2004 gmc sierra ext. cab 4x4 and air or heat will only come out of defrost. wont blow out vents or feet. sounds like there is a vacuum leak, possibly under the hood.. Vaccumm is needed to change the ...

door of a 2004 gmc sierra extra cab with power windows and door locks? its tricky but not hard. remove the door panel and put the window up, look in with a light and it will be obvious what to do.....

...a Can you tell me where the cabin air filter is located on a 2004 gmc sierra 2500 crew cab truck? check under the hood in the wiper cowl, should be an access panel. if not check behind the glove

2004 gmc sierra acts like the key is in the ignition when its not, the warning bell goes off+the doors wont lock ,like the key is in the ignition sounds like either key in cylinder contacts are bad or

...2004 gmc 1500 with dual ac, driver side vents shift from ac to full heat while the passenger side says in ac mode bad blend door actuator maybe there is way to press the buttons on controller to make ...

...2004 gmc sle crew cab truck The 04 SIERRA is behind a panel with 4 screws under the glove box...Remove the screws and cover and slide it out.There is actually 2 in there and it is easy once the cover ...

...door. 2004 was the change off year and 2005 was defiantly the no serviceable fuel filter. You can go to the dealer with your vin number and they can look up in there system if you have the external ...

...rear doors do not lock. every once in a while they will lock. where do i start to look for the problem? thanks Maybe the actuators (electromagnetic) are going bad. I would try to replace that part ...

...WONT OPEN DOOR IS NOT LOCKED ,HOW CAN I OPEN AND THEN GET REPAIRED? This is a pain of a job. you need to remove the drivers seat and then remove the drivers door panel. Unfortunately there is no way ...