...'chisel' end on an angle through the hole in the rear bumper and into the hoist shaft. Turn wrench counter-clockwise to lower spare enough so you can pull it from beneath the van to detach. Good
...Corner marker lamp: 194FH4 clear Rear: Brake/turn light: 4157LL (clear lamp) Lower back up light and top running light: 3057XX (Wagner) (clear lamp) Hope this was easier than taking off the
...rear left gate open, you can look along the top of your bumper surface just under the rubber seal and to left of the gate lock pin by a few inches you will see a hole. This is where the flat tip ...
...rear lamp assembly and was easily removed. In the front the turn signal appears to be in a separate area of the bumper, with no apparent access. 2006 Chevy Uplander Welcome to FixYa.com Park and Turn ...
...rear bumper cover for 2007 uplander removing rear bumper cover Lift the tail gate. There are clips or screws along the top edge. Remove this. The clips all you do is pull the center pin with a panel ...
Usually answered in minutes!
500 Questions
457 Questions
280 Questions
25 Questions
18 Questions