...rear bumper, rotate the bulb holder counterclockwise, then withdraw the holder from the housing and pull the bulb out. In some instances, the license light housing is held to the bumper with clips, ...
...rear bumper next to the license plate. if the vehicle is equipped like that then there should be a few straight bars that attach together to form a long bar. this bar is then inserted into this hole ...
...rear brakes i pumped up tried to bleed there no fluid comming to caliper check for a clog in line replace the brake lines....simple but you will get brake fluid all over you, and you will get filthy. ...
...rear bumper. Be sure the chisel end of the wheel wrench connects into the hoist shaft. Turn the wheel wrench counterclockwise to lower the spare tire. Keep turning the wheel wrench until the spare ...
how do i change the light bulb for the license plate there will be a clip on the inside of your rear bumper to remove the ligt fixture it self then simply pull the bulb out
...bumper on a 2000 Blazer Front or rear, I am guessing it is the rear as they tend to get the most abuse and or rust! Start by removing the plastic step guard on the top of the bumper (use a flat ply ...
...from underneath vehicle there is a hole in the rear bumper, you put the rod from your jack handle into and turn to let it down. Sometimes they get stuck and you have to pull on the tire when
...rear bumper 1999 blazer Hi there:Check this Removal Procedure...1. Remove the rear bumper step pads. 2. Remove the license plate lamps. 3. Remove the nuts and the bolts that retain the rear bumper ...
...lamp's retainer from the rear bumper by pulling the lamp up and tilting the bottom of the lamp away from the bumper. Remove the lamp from the rear bumper by rotating it clockwise or ...
Usually answered in minutes!
2,307 Questions
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions