Questions & Answers for: pump oil gc160

...oil, new spark plug, added fresh gas. It starts with one pull, but only on choke. When I close the choke it stops. Any thoughts on what's going on? Thanks sd You need to remove the carb bowl, then ...

Ad

Question about 2500 PSI Pressure Washer

1 Answer

...run its a preasure washer and i bought a new fuel pump and carb, it will run for about 15 secs and shut off, please help, honda gc160 check oil level. it has a low level shut off switch ?? May be ...

Ad

Question about 2500 PSI Pressure Washer

1 Answer

pump oil content/level. On the pump itself, at the top, there is a black, unscrewable oil cap, with blue-ish oil in it, BUT NO DIP STICK! How do I check the level? What kind of oil, specs etc? Thanks!

Question about Pressure Washer PSI 3000

3 Answers

...oil is needed, one for the "Engine" as previously provided, and the other type is for the pressure washer 'Pump'. This in most cases is a Non Detergent 30 weight SAE. Non detergent blends will Not ...

Question about Pressure Washer PSI 3000

1 Answer

Oil leak appears to be from pump, not engine, GC160. What oil and how much should be replaced. what might be source of leak some pumps have a side glass and oil should be half of side glass and ...

Question about Pressure Washer 2800 PSI

1 Answer

...pump oil but realy its a 30 weight oil if you want the # its AW-4085-0016 or equivlant . The engine oil is a 10 -30 in most tempatures they say use a 30 wight above 40 degrees but i use mobil one ...

Question about Pressure Washer 2800 PSI

1 Answer

pump oil the # is AW-4085-0016 This is MI-T-M spec but with this # you should be able to cross refferance to your pump make in case there is an issue with detegent or non detergent oils it could be an

oil changes etc., it has been trouble free. Any help would be appreciated. replace the unloader of your pump....find the model of the PUMP ...not the washer itself...the pump and find a parts list and

Question about GC160-QHA 3/4" Shaft Recoil Start 5 HP Engine

1 Answer

...pump for pressure washer, engine was on a block of wood, it tipped over and laid upside down for a while, now when pull cord to crank, oil comes out of the exhaust and it won't crank. What to do? ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Garden Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

john h

Level 3 Expert

29492 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...