Questions & Answers for: probe gt ignition relay

...Probe GT can you start the car without a fuel pump relay? Obviously, you can jump the relay but it is dangerous on an extended basis. You'd have pressure in the lines when you don't want it there. ...

...GT): Possible Source(s): § Constant Control Relay Module damaged. § Fan Control (FC) circuitry damaged. § Cooling fan motor (8C607) damaged. G1: CHECK VOLTAGE SUPPLY TO CONTROL FAN l ...

...probe cooling fan ground circuit. If test light illuminates, go to step 1. If test light does not illuminate, go to step 19). 17. Repair open or poor connection in cooling fan ignition feed circuit. ...

...Probe GT fuel flooding problem. The longer it sits unstared, the harder it is to start the next time. I have to hold the gas to the floor before priming the ignition to cut off fuel to my pistons as ...

...gt won't start only has spark when letting the key off If it only has spark when you're letting the key off, try replacing the ignition switch. The ignition module is most likely the problem. The ...

...probe gt 2.5 5 spd will turn over wont start put new distributor in ran for 30 sec then nothing put another distributor in wont start fuel cutoff light on don't know what to do don't want to ...

...GT-S Fuel Injectors Not Firing The car sat for 4 years without turning on. Have restored the fuel tank, bought a new fuel pump, bracket, and sending unit. The engine has turned on once with a rough ...

...probe gt. Replaced the pump and relay has been checked. I am looking for the wiring schematic from pump to fuse panel and fuse panel to ignition circuit. Do you try the cut off switch on the trunk ...

...GT%202550%20%282005%29.pdf Given the starter circuit is misbehaving, if you haven't already, disconnect (at the solenoid) the large gauge wire that feeds the starter motor to prevent it from cranking ...

...gt; and PCM knows tranny is in park or neutral and is GO for cranks. if NOT? the PCM blocks you. (Bad tranny switches)! starter relay DEAD. the PCM happy (and immo) the PCM closes the STARTER RELAY. ...