...primary chain lately. The chain should be adjusted to have 3/4 to 7/8 inch up and down movement when the engine is cold. Remove the top primary plug and you can reach in with your finger and lift the ...
...PRIMARY CHAIN The primary chain on you year of bike my have an automatic adjuster on it ,, they should not have needed to adjust it ,,,,if it was loose then the auto adjuster is not working properly ...
primary chain tensioner on the 1979 Sportster (Not XLX) lays under the chain at the bottom of the primary case. There is a stud that passes through the primary cover with a 1/2" Nylock nut. The teflon
Question about 2000 FLSTC Heritage Softail Classic
...primary chain on the harley davidson Remove the small access plate on the primary cover. Inside you'll see the primary chain adjuster and shoe. Loosen the bolt and slide it up or down to adjust the ...
Primary Chain Wedge (303-533) and Variable Camshaft Timing Oil Control Unit Setting Tool (303-654). See Fig. 232-Fig. 236 . NOTE:"A" bank refers to the right/passenger side of the vehicle and "B" bank
primary chain hitting case on clutch housing, cable nearly fully adjusted clutch slips if adjust any more. bad grinding noise from chain hitting case can i adjust clutch any more in housing? The ...
primary chain but the warranty is between you and your dealer. From my experiences with the dealers, don't get your hopes up though. Now, find the drain plug on the bottom side of the primary back
...primary chain should have 3/4" to 7/8" up and down travel when the engine is cold. As the engine heats up, the aluminum expands and the chain should have 5/8" to 3/4" when hot. Take the inspection ...
Question about 2004 FLHTCUI Electra Glide Ultra Classic
...primary chain tentioner on my Harley Davidson Dyna wideglide inside the primary cover, in the middle bottom part of the chain is a shoe assembly, loosen adjusting bolt to raise shoe which increases ...
Question about 2004 FLHTCUI Electra Glide Ultra Classic
...chain Primary timing chain guide. Tighten the bolt to 10-12 ft. lbs. (13-16 Nm). Primary timing chain tensioner and backing plate. Tighten the bolts to 89-124 inch lbs. (10-14 Nm). Primary timing ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions