Questions & Answers for: Chevrolet plumbing

rear air a/c 1999 express van 1500 rear air is warm, front air is cold Probably plugged or failed expansion valve on rear evaporator. Both front and rear are plumbed in parallel so if the front is ...

...engine on top of radiator=W code) the hose connections between the fuel pump module and the truck plumbing are different in that the Z has simple fuel hose jumpers (relatively low pressure) and the ...

...ideas? Thanks. Many vehicles have a vacuum actuated valve (or flap) internal to the console vent plumbing. The vaccum line going to this valve/vac solenoid may be bad, unhooked or not functioning. ...

...side. You'll find its intake connected to the engines air intake. It's a small squarish box. The plumbing goes into each header. (The small tubes that come off the headers) There are also two

...the side of the base, decreasing it's diameter. Push and turn and the bulb will come out. Go to a plumbing shop or plumbing supply and buy a fitting brush for 1/2" copper fittings. Clean the ...

2 oil senders on chevy 350 I swapped a 350 to early 400 & you sloved my problem w/knock sensor. The 350 has 2 oil senders. 1 can type other regular but w/2 prongs. Can located under dist plumbed ...

...out of the plug. the relay which is controlled by pressure and temperature sensors on the a/c plumbing and in the

...valve where i need to attach to. The low pressure side port is located somewhere on the 'thicker' plumbing vs. the 'thinner' plumbing coming off of the compressor. The pressure should be 25psi to

i have a 1986 chevy K10 350 carberated that has a fuel line problem from the mechanical fuel pump up to the carb. its not pumping any fuel up to it, i've replaced the mechanical fuel pump and the ...

i have a 95 chevy silverado with a 350. i have fuel to the trottlebody but not the injecters. why? It seems like the fuel line may be plumbed up to the wrong place. The throttle body only regulates ...