Questions & Answers for: plenum

...gasket? How about any advice. The best way to remove the rear valve cover is to remove the intake plenum. There is really no other way to do it. It is not a hard job, removing the intake plenum,

Ad

...do I change the heater core in my 1984 grand marquis? I dont have a manual you have to remove the plenum case behind the dash. I will provide 94 gr marquis. don't have 84.

Ad

Question about 2001 Durango

2 Answers

...definitely do it yourself. The following text is from the 2000 Durango service manual. The "Cowl Plenum" is some plastic on the front of the dash. For my 2001 I didn't have to remove that, It was ...

Gettting the intake plenum off a 02 freelander I have all the sensors,vacuum lines off etc..... all bolts that I see, its definately loose but not coming off. My 2002 Land Rover Freelander V6 ...

I need to remove the upper intake manifold plenum. All of the obvious bolts are out however the plenum still wont come off. Are there any hiden fasteners inside the plenum? There are no fasteners ...

Question about 1990 Town Car

1 Answer

leakage.3. Remove the 3 nuts located below the windshield wiper motor attaching the left end of the plenum to the dash panel. Remove the 1 nut retaining the upper left corner of the evaporator case to

...System1992 Town Car/Crown Victoria/Grand Marquis Workshop Manual REMOVAL AND INSTALLATION PlenumRemoval Disconnect battery ground cable.Disconnect the heater hoses from the heater core

Question about 1993 Grand Marquis

1 Answer

...coolant spillage. 3. Remove bolt located below windshield wiper motor, attaching left end of plenum to dash panel. 4. Remove nut attaching upper left corner of evaporator or heater case to

Question about 1993 Grand Marquis

1 Answer

Air Handler V coil drip into Plenum My upstairs air handler v coil drips inside the plenum return. I have to put a bowl in the return plenum to catch condensation. Drip pan not blocked. Refrigerant ok

Question about 1993 Grand Marquis

1 Answer

...this unit? There is air flow but can't get it to come through the vents. The problem may be at the plenum. If the ductwork is connected at the very top of the plenum it can't build up STATIC

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...