...sensor (KS)The PCM carries out the following functions: accepts input from various engine sensors to compute the fuel flow rate necessary to maintain a prescribed air/fuel ratio throughout the entire ...
...PCM and the sensor. If you do not, remove the offending wire from the PCM and then check for proper voltage at the PCM pin. If it's present now, repair short on the circuit. If it isn't present after ...
Sensor 1) and ECM/PCM (A1). Turn the ignition switch OFF. Disconnect the ECM/PCM connector A (31P) and the A/F Sensor (Sensor 1) 4P connector. Check for continuity between the A/F Sensor (Sensor 1) 4P
...Sensor 1) and the ECM/PCM. Turn the ignition switch OFF. Jump the SCS line with the HDS. Disconnect the A/F sensor (Sensor 1) 8P connector. Disconnect ECM/PCM connector B (24P). Connect A/F sensor ...
pcm One of the emission sensor is not being recognized by the pcm (computer in the car) after being changed out. My mechanic stated they believe the PCM is corrupted in the section where this emission
...PCM and mainshaft speed sensor. If continuity is not present, reconnect mainshaft speed sensor harness connector. Measure resistance between 25-pin PCM harness connector "B", terminals No. 15 (Red ...
...PCM and mainshaft speed sensor. If continuity is not present, reconnect mainshaft speed sensor harness connector. Measure resistance between 25-pin PCM harness connector "B", terminals No. 15 (Red ...
...sensor? PCM= Powertrain Control Module. It is the brains of the car, it reads the sensor in put from all sensors including the cam shaft position sensor PCM , power control module, engine ...
...PCM detects TP sensor voltage at PCM terminal 89 below 0.10 V after engine start, PCM determines that TP circuit has a malfunction. POSSIBLE CAUSE • TP sensor malfunction • Connector or terminal ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions