brake's.The valve is mounted on the frame(left side)just behind the tire.The valve look's like the letter T you'll see two or three brake line's going in and coming out of it.It was a dealer only part
brake on,choke the wheels and leave it in park the b4000 and ranger are known to have valve body seal problems. they tend to lap over the valve body and cause the problems your describing, id bring it
...valve It was not sending any brake fluid to the back but it was going to the front. He then bled the brakes, over and over and over after the new installation.... He bled everything, all valves and ...
PARK BRAKE & / or Cables , THE BRAKE HOSE (RUBBER) from body to Axel can Fail on the INSIDE in a Way that it HOLDS Brake Fluid IN the Rear Axel (LINES) "STEAL" It sounds Strange But in My 30 years
...park, stopped and low speeds around 1200 RPM. Now it's around 500 RPM. Have you tried cleaning the throttle plates and idle air control motor Try cleaning the idle air control valve. On the 4.0 SOHC ...
...park brake at the boat launch...the rear brake on the drivers side was dragging and getting very hot, eventually wearing out the shoe. I have since changed the shoes, drum and wheel cylinder and on 2 ...
...park with the emergency brake set.Heater Controls. Step 1 - A heater cannot operate unless the engine is full of coolant/antifreeze. ...Refilling Cooling System. ...Engine Thermostat. ...Blend Door ...
park brake, get under there you will see cable on side of transmission. Using a long screwdriver pop the cable off the position lever, don't be afraid to use some force, it can be a little hard to pop
Question about 1997 Ranger SuperCab
brake-fluid. If CHANGED at recommended intervals... these systems could go for MORE than the (nearly) two decades accomplished here by your system (summary: not a hot point). You can probably get some
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions