...park break is applied? If so the check your proportioning valve if the truck has an abs system then the valve will be called a rabs valve.( located on the frame rail under the driver side seat) Check ...
...brake fluid container 2.) start the car leave it in park or neutral 3.) have some push the braking pedal right down as they are doing this look for air bubbles in fluid container, in some cases you ...
...valve. i changed egr ( 2weks ago ) truck ran great until friday. changed EVP and IACV yesterday, did diconect bat cable, drove 20 miles and truck is still surging and dying ( not at every stop ) ...
...valve If the brake light is on, this tells me that the level could be lower than normal. If the brake level switch is bad, replace. But, I think that you need to check that level. If the brakes are ...
...valve body gaskets.Check with the service manual before you throw away the old gaskets.Remove any traces of the old pan gasket from the oil pan.Make sure the mounting flange of the oil pan is not ...
...PARK (A/T), or NEUTRAL (M/T) Parking brake is applied (automatic brake disconnected where applicable) Wheels blocked Engine at operating temperature Proper fuel pressure and no exhaust smoke Correct ...
...Brake Applied Failure P1662 IDM EN Circuit Failure P1663 FDCS Circuit Failure P1667 CID Circuit Failure P1668 PCM -IDM Diagnostic Communication Error P1670 EF Feedback Signal Not Detected P1690 ...
...brake thinking that it might be creating pressuer on the switch that activates the warning light. No luck.' Thank Sounds like the RABS(rear anti-lock brake system) valve is bad, need to replace
Question about 1991 F250
...stud. If it clicks it should be okay and the ground okay. Be sure to have the vehicle in park or neutral with the parking brake on before doing this, because you are bypassing
Usually answered in minutes!
907 Questions
705 Questions
546 Questions
442 Questions
465 Questions