Questions & Answers for: Chevrolet Venture park brake valve

Question about 1997 Venture

3 Answers

...brake pedal at least ten times, then ope bleed valve at back of wheel cylinder, do this until you hear a spitting sound, which indicates air, do this at every wheel in this order, RR, LR, RF, LF. ...

Ad

Question about 2002 Venture Passanger

1 Answer

...the emergency brake on my 2002 Chevy Venture. It will not release so I want to disengage it completely. go under the dash and manually release the ratchet pawl that engages the park brake ...

Ad

2001 chevy venture Rear Parking Assist not working Normally it will not work when the brakes are worn out so an inspection is needed to determine this is your problem sorry. I disagree with the rear ...

...valve until air or fluid squirts out,while holding brake pressure even if goes to the floor dont release pedal until bleeder valve is tightened or you will **** air back into the line,do this several ...

Brake Pressure Modulator Valve (BPMV) are mounted on a bracket attached on the left strut tower. Wheel Speed Sensors, brake fluid level, brake hoses and lines, inspect and replacement, Brake hydraulic

Question about 2000 Venture

1 Answer

valve from engine to brake booster is not clogged to check this pull it out of valve cover and shake it if it rattles it is good if it dont rattle it is clogged,replace it if pads and linings are good

Question about 2001 Venture

1 Answer

...brake pedal the adjuster actuator and actuator spring keep popping off how do i fix this problem? Parking brake lever on leading shoe (end of retractor spring in its hole on the leading shoe). Make ...

...park. When you shut it off, the key will not come out Check if the brake light come on when pressing the brake paddle?, IF brake lights do not come on then replace the brake light switch and ...

Question about 2001 Venture

1 Answer

no brake lights have parking lights but no brake lights or interior lights have you checked the fuses

the emergency brake before placing it in park. shift linkage break you have to replace.to make job easier buy a haynes repair manual it will show and tell you how to fix broken shift linkage

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...