Questions & Answers for: mercedes 190e idle

mercedes 190e 2.6 auto,starts fine when cold but idles rough and hesitates for ten minutes untill warm then fine, starts fine when warm but idles rough and hesitates for 1 minute MAY REQUIRER THROTTLE

idle problem 190e petrol cold start valve needs replacing & the previous owner has damaged injector housing & fast idle adjuster.garage said i need a new housing. or scrap it! what can i do to save my

...190e 2.6 My Mercedes Benz 190e has an SRS light problem. It is on most of the time but turns off intermittently while driving. Any ideas? Check the seat belt wiring under your front seats, seat belt ...

...real high I have a 93 190e 2.3 liter 5 speed lately its been idling real high at around 2000 rpms. I was wondering what to check first? poss ur idle air control valve is dirty or bad check thaty ...

...1991 MB 190E 2.3 idles too high around 1200 RPM and wont go down even when warm; what can be wrong? Intake manifold or vacuum hose vacuum leaks or a sticking idle speed control valve will cause

...Mercedes 190E 4Cyl.Surging.In speed or neutral. Check for a manifold vaccuum leak, or an opening between the MAF, (mass air flow sensor), and the throttle body. The easiest way to check is to spray ...

Mercedes 190E 2.0 1993 idling high and ABS not operating My mercedes 190e 1993 2.0 idles high (1500 rpm). It is a automatic. The ABS light also indicates that the ABS is not operating. When the light ...

automatic transmission problem on my 190e reverse is working ,on D when idleing it goes forward very slowly when you step on gas pedal it reaches high rews with no response still rolling very slowly? ...

idle benz 190e The idling of my 1987 MB 190e m102 2.3 engine is very low when not warmed up..only about 500 rpm....and becomes very high when warmed up. When the aircon compressor turns on....the idle

190e engine idling sometimes engine turn off Please help! 190e engine idling sometimes engine turn off A couple of years has driven without air controller not connected (IAC) was set on the screws ...