...washer fills, agitates, and drains perfectly, it just wont spin. Leaving the lid open and pressing the switch with a pen makes no difference. It even makes all the appropiate sounds and there are no ...
Question about Legacy Series Top Load Washer
Washer walking across the floor in spin cylce The machine in question is 2/1/2 years old. We have re balance it many times. It has started to 'walk' across the floor in spin cycle. Is there a way to ...
...Maytag top load washer will not agitate in the permanent press and normal cycles. It will agitate in the delicate cycle however. It fills, spins, and empties at the appropriated times also. try a new ...
...Maytag model A490 clothes washer. It works fine up to the rinse cycle and then shuts down. When it reaches this point it has become necessary to manually advance the dial a short ways whereupon it ...
...washer stops at a certain minute and won't proceed (i.e., it stops at 11 minutes for the low extract spin only cycle). Very frustrated! It worked fine for the service guy yesterday! it may be in its ...
Question about HAV3460AWW Top Load Washer
maytag washer issue. the water will not stop filling ... it would literally run over. it will fill all the way up and never stop. i have to turn the knob to the rinse cycle or turn off to get to stop
Question about Atlantis MAV6000 Top Load Washer
...maytag atlantis washer mav35 when its in the Permanent Press Delicate mode the water does not spin out at the end of cycle. To release the water i have to spin the dial to spin in the Regular mode. ...
Question about MAH6700AWW Neptune Front-Load Washer
Maytag neptune stackable washer-not sure of the model-door is locked and cannot open-cannot start another cylce to try and clear. Unplugged machine-still lock button on and cannot open. This machine ...
Question about Neptune FAV6800AW Top Load Washer
..."" it goes off balance in the reverse cylce. I just put a new clutch in. "" Is that the Spin Cycle? Wash basket is rotating CCW is that correct? Did you follow this post for the Clutch replacement? ...
Question about Neptune FAV6800AW Top Load Washer
...Maytag washer go into spin cycle? I would start with the timer module. The spin cycle requires a lot of current (amps) to move the mechanism and load. That current can cause contacts inside the timer ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions