...before the agitator begins. The settings on water level may be set on very low amount. Check see your water level is set on medium or full. You may be expecting the wrong amount on the low
Question about WDSR2080D Top Load Washer
...5/18/07 from LOWES. If you disconnected power and water still flowed, replace the water valve. If water stopped flowing when power was disconnected, clean out tube from tub to water level
Question about WSM2780DWW Unitized Spacemaker Washer and Gas Dryer
...low water level Sounds like a faulty water level switch. It is a diaphragm-like device with a small plastic tube attached between the switch and the bottom of the washer's outer tub. As the water ...
low water level in top load washer we have a ge top load washer and the water level is too low to cover even a regular load Load selector switch has a hose attached to it that goes to bottom of washer
...water level switch and blow through it to make sure it is clear then reattach and try the cycle on a low level setting. if this does not fix your problem then you might have a bad water level
low water levels this is a low water use machine. the EPA has mandated the amount of water a washer can use in the US. sorry what you have is what you get
...level required as low, medium etc.The water level sensor will cut off the inlet valve when it reaches the desired set level. The water level should be a little over the clothes put into the
Question about WBSR3140DW Top Load Washer
...WATER LEVEL LOW CAN I CHANGE THE SETTING ON WATER there should be a knob on the control panel showing small, medium, large maybe even super. that is how you change the water level. Its for different ...
Question about WBSR3140DW Top Load Washer
...not stop filling in tub what would cause this The water level switch shuts the water off when it gets to the desired amount. Also change the water level to low and see if it stops at different
Question about WBSR3140DW Top Load Washer
...low-water flow error. It could be a problem at the inlet (shut-off closed, low flow through the hoses), the inlet valves, the pressure sensor/air tube that checks how much water arrived in the tub in ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions