Question about 2-wire Pull Chain Light Switch For Ceiling Fan Lights
...switch wiring in a ceiling fan light kit 1 blk, 1 wht wire coming down thru fan to 4-light kit - replacing 2-wire pull chain switch, but (dummy me) removed old b-4 noting how wires were connected - ...
Question about 1997 Wrangler
light switch. When I hook up my leads I found two wires that are ''hot'' when everything is off, including the door switch. Is a connector off of the wiring harness somewhere for this options? My jeep
Question about Ivory Decora Switch & Pilot Light 20a 5637-i
...light switch and should be wired as any other SP switch. The only difference is that is has a pilot light. All the white neutral wires are tied together and then pushed back in the box with none ...
Question about Classic Hugger Polished Brass 52" Ceiling Fan
...light switch. I am replacing a ceiling fan light kit switch. It is a pull chain switch with a black wire, a blue wire and a red wire. The pull chain switch controls four lights and a single light ...
...light switch but wires don't match the colors on my hamton bay fan what wires go where i have a black wire and a brown wire and a grey wire on the switch in the hamton bay i bought westinghouse 3 way ...
Question about Legrand TM8111 Three Single Pole Switch
...light. the current switch has a 14-2 wire connected to it. i have run a 12-3 wire from the ceiling box to the existing switch box. im not certain how i should hook up the 12-3 wire to the new triple ...
light switch on a extetion cord You want a light switch on extension cord. What kind of light switch do you have? You posted under GFCI device which is totally different than ordinary wall switch. And
...light switch with 3 wires that have to be hooked to it.3 black wires 3 white wires and 3 ground wires.The light switch has 1 place for the black 1 place for white and 1 place for ground. You have 3 ...
Question about 2004 Taurus
...light switch is not always switching off. Try getting at the back of the switch and figure out which wire goes to the park lights (probably one of the smaller wires, you can possibly identify ...
...switch the light that stays on must be wired to the wrong side of switch. disconect both wires from both lights and double them up and reconect them where the light that turns off was wired check ...
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions