turn key to start and nothing I have a 01 tacoma with 3400 moor, 4x4, 85k miles. Turned key this morning and nothing. No lights on dash, clock dead everything? Doesn't seem like a battery or ...
Question about 1999 Tacoma PreRunner
...jumper cables up thinking it was battery but it still made clicking noise. I tapped waht i assumed was the starter and it started right up this problem is caused by burned contacts inside the starter ...
...light is on continuously now. can i get a trouble code by placing a jumper wire between 2 terminals and if so which terminals and where are they located? Your Tacoma is OBD II. There are no jumpers ...
...jumper wire from your marker light positive to the lower contact in the fan control relay socket will operate your fan when parking lights are on. The larger vehicles with more powerful radiator fans ...
...light. The one that doesn't is the ground. You can either trace that wire to where it goes to the body (ground) or clean off some of the insulation and run a jumper ground from the ground wire to a ...
...jumper the power in and out for the headlights to bypass the relay - or use a test light to see if you are getting the right voltage on each pin. If you ground the relay with a test light the ...
1991 f 150 no crank has new starter and relay in law has 1991 f150 5l changed out starter and relay,battery has good voltage also used jumpers to make sure, problem is, turn key on shows voltage on ...
Question about 2002 Tacoma
...light this is done with the key in the on position engine not running for example code 13 would have one long blink followed by three short ones you can also use a scan tool with the right adapter if ...
light should flash two times per second. Switch off the ignition. Remove the jumper wire. Hope that works. If problem persists, contact a service personnel. Are you sure it's the ABS light and not the
Usually answered in minutes!
352 Questions
307 Questions
394 Questions
295 Questions
304 Questions
