...jumper it until I can get to a repair shop? If so, how do i do it? what should i be careful of? Don't know if you tried this but sometimes a little light oil in the key slot will free it up. Also try ...
...jumper cables... Thank god for the Fuse and thank you to Fixya.com that I was able to determine this so quickly!!! you short circuited a diode in the dash cluster Thank you everybody, who contributed ...
...light flashes for 2 seconds, turn the ignition switch "OFF". 13. Remove paper clips/jumper wires from the OBD II connector. Drive your vehicle to confirm VSC & TRAC warning lights have been reset ...
...light went on during my drive to work. When I left work and walked to my car there was a loud humming noise coming from it. Opening the hood, I could not locate the exact source of the noise, but it ...
...light can come up including ignation key check vehicle battery connections for obvious corrosion. If none is present, use another vehicle and battery jumper cables-properly hooked up, and with 2nd ...
will not start replaced battery. after replacement lights come on but will not start no crank or no start. which is it the car with A/T it must crank robustly to start. robustly means 250RPM, min. or ...
Question about 2005 Sienna CE
...jumper cables (buy the ones with lowest gauge copper wires) !!! ok real boost fails., so that means the starter system is failing not how i didnt say a part. bad ! i then try to crank car, with ...
Question about 2014 Sienna
...vin 5tdk es078584 Was running fine came home parked in garage next morning everything was dead no lights or dash completely dead. The battery was 12.8 volts, cleaned the connections. Tried to
Usually answered in minutes!
572 Questions
501 Questions
377 Questions
382 Questions
333 Questions
