Questions & Answers for: lid locked

Question about Neptune FAV6800AW Top Load Washer

1 Answer

...lid is locked signaling from lid locks slide switch in the lid lock. I think you may corrosion build up in the left lid lock such as the Pic?s I will attach show of other users. The left lid lock is ...

Ad

Question about Neptune FAV6800AW Top Load Washer

1 Answer

...Lid is Locked? signaling are in parallel going back to the control board that is why you need to pull the plug on the right lid lock after replacing the left lid lock. The lid locks are designed to ...

Ad

Question about Neptune FAV6800AW Top Load Washer

2 Answers

...Lid is locked signaling. when they lock. Do you take a "FL" error code for failed to lock? I would remove the right hand lid lock and troubleshoot the Left Hand Lid lock. Only the Left Hand Lid Lock ...

Question about (IWL12)

1 Answer

i get sevice code 234, what does it mean 234.(11101010) Phase 6 - Lid Lock Open Circuit Check Harness to Lid Lock and connections at the Motor Control Module and lid lock ends. Primary Fault: ...

Question about Paykel EcoSmart GWL15

1 Answer

...and paykel gwl15 has a code 234? cant find any infoon this code Fault code 234 234. (11101010) Lid Lock Open Circuit Check Harness to Lid Lock and connections at the Motor Control Module and lid ...

Question about Paykel EcoSmart GWL15

1 Answer

...lid is now locked for the entire cycle. When the lid is locked the Lid Locked LED will illuminate. Once the spin has completed, the lock will release and the lid can be opened. To open the lid during ...

Question about NTW4700YQ Top Load Washer NTW4700YQ

1 Answer

...locked and lid was not put down before it locked, which is why the light is flashing. Therefore, push the "START" button until you see the lid lock button is off (Approx 3 seconds). Once it is off, ...

Question about Neptune FAV6800AW Top Load Washer

1 Answer

why does my lid lock keep flashing? changed lid lock but having the same problem. There is a right lid lock and a left lid lock which did you change? The left lid lock is a lock and the reed switch ...

...lid is not locked. Assuming the lid is actually locked, then this might occur because of a bad wiring connection (check the lid lock switch assembly and the cabling at the controller) or a bad lid ...

WL80T65CW1. Why is it displaying fault 234 and will not cycle? I OPENED THE LID LOCK & IT LOOKED A SALTY CORROSIVE TEXTURE ON EACH END OF CONNECTION. ALSO THE TOP LID GROOVE THAT SLOTS INTO THE LID ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...