...small thin boards and making sure the machine is level. If this doesn't work there could be a bad sensor, but that doesn't seem like the case to me as moving the machine a little gets it to
...to adjust water level This is to be adjusted on the water level sensor , normally there is a pressure sensor mounted on which the level can be adjusted .Also the settings can be adjusted on the
...level sensor The machine just keeps filling water. Could the pipe to the level sensor be blocked. Or how does the level sensor work Or the water level sensor is defect, or a cable got lose. or the ...
Question about AWS76NW Top Load Washer
Do I need to call a technician? Check the lint filter drain from clogging... socks have a tendency to lodge inside. If the drain is clogged, the water level sensor will not advance the program to spin
Question about 3.3 Cu.Ft. Heavy Duty Top Load Washer, AWN412
...the tub that runs to the pressure sensor that shuts of the water inlet could have a small crack in the tube or have water in it could be the level sensor itself or the knob that does the level ...
Question about 3.3 Cu.Ft. Heavy Duty Top Load Washer, AWN412
level required to dry clothes, the control panel shuts off the heater. The panel will turn the heater on again and begin another heating cycle when the thermistor indicates that more heat is needed to
Question about 3.3 Cu.Ft. Heavy Duty Top Load Washer, AWN412
level required to dry clothes, the control panel shuts off the heater. The panel will turn the heater on again and begin another heating cycle when the thermistor indicates that more heat is needed to
Question about 3.3 Cu.Ft. Heavy Duty Top Load Washer, AWN412
...water from the top during washing water spills from top of outer tub ring. Is it overfilling, too close to the top? If so, replace the water level sensor. Some have an adjustment screw in the
Usually answered in minutes!
123 Questions
44 Questions
40 Questions
24 Questions