Question about 3.8 cu. ft. HE4t Front Load Washer
Kenmore 3.8 cu. ft. HE4t King Size Capacity I finally purchased the stands for my washer and dryer, what is the right way to install them? remove feet set on stand and put the 4 screws in 2 in the ...
...Level" button for 3 seconds and voila, I can dry my clothes again :) when i use our kenmore elite the last 12-15 minutes of it's cycle it stops working and wont finish the cycle and it just flashes ...
Kenmore HE4t washer just developed a severe balance issue. I've confirmed that it's level and the floor is solid. At any spin speed and with just about any clothes / towels, it goes jumping across the
...kenmore elite quietpak he4t How do you level washer? adj all 4 feet all the way in..try to rock washer adj front feet as need to give washer as solid footing as possible tighten lock nut in top ...
Question about Elite 45986 Front Load Washer
...kenmore washer rubber drum gasket not attatched. The drum gasket is not attached in front and it's leaking water. I opened up the bottom front panel and it looks like the counter balance came loose ...
...he4t mean. The F33 error code indicates a pump drive system error. If the pump ohms out correctly & the harness is secure I recommend replacing the CCU (central control unit). Please see the ...
...level higher than normal? RE: kenmore he4t washer error code (fh) clip this post email this post what is this?see most clipped and recent clippingsPosted by cat88 (My Page) on Sat, Feb 25, 06 at ...
...open and allow the watter to come into the drum. If not the valve is not working and so the water level sensor wont be activated which has to trigger the main controller to start the wash cycle. So ...
Question about 3.8 cu. ft. HE4t Front Load Washer
My He4 starts to spin and makes a loud noise, like it's going to take off. I did check the level of the machine and it is good. It does appear that the nylon ring around the drum is melting. Is there ...
Question about 3.8 cu. ft. HE4t Front Load Washer
kenmore washing maching overflow after washing The pressure switch, also called the water level switch, is what control the amount of water goes in the machine, If your machine is constantly filling ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions