Questions & Answers for: jeep wrangler 3.6 engine

jeep wrangler with 31" tires and 2" lift, recently had throttle cable replaced as well as a rebuilt engine put in. specs check ok on engine. jeep won't go past 57 mph, rpms stay at 3, if you back down

...Jeep Wrangler 4.0 When Driving the Engine Dies The Engine Just Stops Running but it isnt giving any check Engine Light How do I find out what it is? My 2002 Jeep wrangler, 6 cyl automatic, will just ...

...jeep wrangler that won't idle. i have a 1988 jeep wrangler that runs fine but won't idle. I have to keep reving for it to run. it dies if you let up on the gas. 1. check for vaccuum leaks. 2. check ...

...wrangler If I am looking at my engine while standing in front of my 2000 jeep sahara inline 6 cylinder,which cylinder is the #3 as I would start counting with the cylinder closest to me? from the fan ...

...jeep wrangler starts jumping and backfiring 1989 jeep wrangler after jeep warms up driving down the road jeep starts bucking and backfiring. Help! Start with the basics...meaning check the spark plug ...

jeep wrangler 2.4l spark plug wires were disconnected I need the wiring diagram to reconnect 2.5L engine. 1 3 4 2 Number 1 should be approx 5 o'clock position, the order goes clockwise. Next time mark

...Wrangler: engine maintaince light comes on for 3 seconds the... Engine maintaince light comes on for 3 seconds then turns off when i turn the ignition key? that is the engine management system ...

...Pressure Sending Unit on a Jeep Wrangler 2000 6cyl so i can replace? Oil Pressure SensorThe 3 wire, solid-state engine oil pressure sensor (sending unit) is located in an engine oil pressure

firing order for a 94 jeep wrangler 2.4l for 2.5L engine, autozone says Firing order 1-3-4-2 --Distributor rotates clockwise

jeep wrangler with a 2.5 engine without power steering There should be a sticker in the engine compartment that shows the routing and you should be able to hold the tensioner back with a 3/8's ratchet