...Torque intake manifold: Step 1: 12 inch/Lbs, (hand tight) Step 2: 72 inch/Lbs, (6) Ft/Lbs Step 3: 12 Ft/Lbs torque intake plenum: Step 1: 24 inch/lb (hand tight) Step 2: 48 inch/lb (4) Ft/Lbs Step 3: ...
...intake manafold? The torque specification is a 2-step process; tighten the vertical lower intake manifold bolts (the four middle ones) to 7 Nm (62 lb in). Tighten the diagonal lower intake manifold ...
...Intake manifold torque sequence-3.7 & 4.7L engines Hope this help (remember comment and rated this). attached is the picture of the torque sequence for bolts and the torque specs. as u can see ...
...need a sequential order followed by how many degrees and Lbs of pressure. if its on the intake i doubt it needs an specific torque. just try not to crack the intake manifold since its made of
Question about 2002 Ford Windstar 3.8L Intake Manifold & Valve Cover Repair Kit New
...TORQUE SPECS INTAKE MANIFOLD AND SEQUENCE NEED SEQUENCE AND TORQUE SPECS UP AND LOW INTAKE MANIFOLD always start in the middle, then work your way to the ends on alternating side bolts, bolts are ...
Question about 2002 Ford Windstar 3.8L Intake Manifold & Valve Cover Repair Kit New
...torque the intake bolts when installing the intake manifold? It is recommended as most intake manifolds are either cast iron or cast aluminum. Uneven torque can result in warping. Too little torque ...
...Intake torque specs ' FordForumsOnline.com www.fordforumsonline.com > Ford Tech Forums > Engine & Drivetrain May 7, 2010 - 2 posts - ?2 authors ISO torque specs for the intake & plenum for a ...
Question about 1998 Windstar
...Intake torque specs ' FordForumsOnline.comwww.fordforumsonline.com > Ford Tech Forums > Engine & DrivetrainMay 7, 2010 - 2 posts - ?2 authorsISO torque specs for the intake & plenum for a 98 ...
Question about 2003 Intrepid
...torque. Upper Intake Plenum: When installing the intake air plenum , be sure to catch the four center bolts and the two side bolts (stiffener brackets) before tightening , The center bolts should be ...
torque the intake manifold to? ... My haynes manual says to torque the upper manifold bolts to 13-16 ft/lbs ... Supporting Maxima.org Member. valve cover and intake plenum bolt torque specs - Maxima .
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions