Questions & Answers for: install intake

install: Fig. Lower intake manifold bolt torque sequence-3.8L (VIN K) engine Clean all parts well with degreaser, especially the gasket seal surfaces on the upper and lower manifold pieces and between

...Install intake manifolds bracket and 4 bolts. Tighten bolts to 32 ft lb (45 Nm). Install grounding bracket. Connect fuel hose to fuel connector assembly. Connect the following electrical connectors; ...

...Install the intake manifold gaskets. Align the coolant bypass tube with the opening in the intake manifold and install the manifold. Tighten the bolts to 11 lb ft (15 Nm). Install the electrical ...

...Install the upper intake manifold gasket. 2. Install the upper intake manifold. Use care not to pinch the injector lines between the upper and lower intake manifolds. 3. Install the upper intake ...

...Install the intake manifold, fitting the plenum duct over the intake manifold duct. Loosely install the intake manifold bolts. Intake manifold torque sequence-4.6L engine Tighten the intake manifold ...

...intake. Install the solenoid valve mounting bracket and power steering support brace to the intake manifold. Connect the heater pipes to the intake and front cover. Attach the coolant bypass hose to ...

Install air intake assembly and top half of the air cleaner assembly. Install the brake vacuum pipe. Fill the cooling system. Connect the negative battery cable, then start the vehicle and verify that

Install the intake manifold gaskets with the port blocking plates facing the rear of the engine. Factory gaskets should have the words "This Side Up" visible. Apply gasket sealer to the front and rear

Install the intake manifold, and tighten the intake bolts to 15 ft. lbs. (20 Nm), rotating the tightening sequence. Reconnect the fuel injector electrical harness connector. Couple the fuel supply and

...Install upper intake manifold and hand start all attaching bolts.
5)Tighten bolts gradually starting in the center working outward until a torque of 12 Nm (105 inch lbs.) is obtained.
6)Install ...