Questions & Answers for: install ball joints

...ball joint. Install the steering knuckle with wheel hub and bearing attached. Install the tire and wheel. Lower the vehicle. Check the front wheel alignment. these jouints are pressed in and there is ...

...ball joint snap ring is fully seated. 2. Always install new: Snap rings. Castellated nuts. Cotter pins. Upper ball joint nuts. 3. Observe the following torques: Outer tie rod end castellated nut: 52 ...

...find at a local automotive store.Remove brakes and control arms to easily get to ball joint and start the removal. The ball joint kit has instructions on how to remove and install your new ball

...Install the ball joint-to-lower control arm. Install a new ball joint-to-lower control arm nut. Tighten the stabilizer shaft bolts to 35 ft. lbs. (48 Nm). For 1988-91 vehicles, tighten the ball ...

...press to remove the ball joint from the suspension arm-note the location of the receiver cup ! For installation of the ball-joint, use the same tool when pressing the ball joint into the suspension ...

...install: Attach the new ball joint to the lower control arm with 3 mounting bolts and nuts. On Deville and Fleetwood, the bolts must be installed from the top of the control arm. On Eldorado and ...

...ball joint assembly. Install Remover, Special Tool 6919 on the top of the ball joint assembly. Using the arbor press, press the ball joint assembly completely out of the lower control arm. NOTE: When ...

install the upper ball joint, assemble C-frame assembly, Ball Joint Receiver Cup D81T-3010-A5 and Installation Cup D81T-3010-A1 and D81T-3010-A3 or equivalents inside cup D81T-3010-A4 or equivalent in

...ball joint stud.Install the grease fitting on the bottom of the ball joint. Use a c-clamp to push the piston back into the brake caliper. Reinstall the wheel assembly. Here you can find the quality ...

...Install the ball joint (4) into the control arm (2).Install the 3 ball joint bolts (3) and the nuts (1). Follow the instructions in the ball joint kit. Tighten the ball joint bolts (3) according to ...