Questions & Answers for: Oldsmobile ignition coil

Ignition Coil Could the Ignition coil be the reason why my 1994 Oldsmobile eighty eight will not start I own the same car. I would need more info on what happened to be begin with why you think it is ...

...Ignition Types I and II On Type II coil packs, the coils can be replaced separately and the ignition wires are all on the same side of the coil pack. With Type I Ignition With Type II ...

...ignition coil to the Ignition Control Module (ICM). Remove the ignition coil. Before testing, visually inspect the coil for carbon paths or cracks which will contribute to weak spark symptoms. Using ...

...of ignition coil Could ignition coil fail/burn out due to leaking gasket? Its very possible that the oil caused the ignition coil to fail,I would suggest that you repair the valve cover

...coil packs The ignition coils are secured to the module with retaining bolts/screws-3.4L engine shown......3 coil packs 3 - two towers per coil ...

...packs, the coils can be replaced separately and the ignition wires are all on the same side of the coil pack. With Type I Ignition With Type II Ignition Hope helps (remember comment and rated

ignition coil, and a faulty ignition module can cause any one of these systems or all of them to malfunction. That does sound like a malfunction with the ignition module inside of the distributor, and

...coil pack unit. On Type II coil packs, the coils can be replaced separately and the ignition wires are all on the same side of the coil pack. With Type I Ignition With Type II Ignition Hope

ignition coils were used on 1988 Cutlass Ciera. Type 1 is a single unit with 3 coils built into it. If one coil goes bad, you must replace the entire unit. Type 2 incorporates 3 separate coils mounted

...ignition coil has to be good. then the ignition control module inside the distributor has to be good. It controls the ignition coil firing times. This module can be tested at a parts store. And then, ...