Question about 2001 FLHT Electra Glide Standard
...idle speed. Or not. If the bike had been running OK and nothing has been adjusted, the idle jet (carb)needs cleaning out or the MAS/throttle body(injection) needs attention. Other reasons include ...
Question about 2002 FLHT Electra Glide Standard
...idle after it warms up, you may have a problem with the slow speed jet being clogged up or a vacuum leak somewhere. If the bike has been sitting for a long while, the carb is probably in need of ...
Question about 2002 FLHT Electra Glide Standard
...idle mixture screw all the way in and then back it out one turn. It should start there. The jetting should be something close to a 29.5 slow speed jet and a 70 or 72 high speed jet. Make sure you ...
Question about 2000 FLHT Electra Glide Standard
speed idle when it's really cold outside in the mornings! Won't hold a steady idle until the weather temperature is about 45 degrees outside or above! it is the jetting in your carb if it only does it
Question about 2000 FLHT Electra Glide Standard
idle and up to about the 2000 rpm point on most rubber mount machines. This is because the rubber mounts are designed to dampen the high frequency vibrations at the engine speed people usually ride at
Idle speed around 2000 rpm, 1st ride of the year , had this issue. I followed my Manual info and adjusted Cold and Hot adjustments. When restarted the idle was close to normal, but after a minute or 2
...idle speed screw (throttle stop screw) is located on teh top right of the carb. You may have to remove the air filter cover to see it. Clockwise raises idle speed. If your bike is fuel injected, you ...
2003 flht idling problems at low speed If it's carbed, check your slow jet, it may be clogged.
Question about 2002 FLHT Electra Glide Standard
...idle or when shifting at low speed? Cause? Cost to fix? recently had lower end of engine rebuilt. Compensator replaced, cams, pushrods. With a bottom-end rebuild, I assume the engine was removed from ...
Question about 2000 FLHT Electra Glide Standard
...idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM. 9. Air/fuel mixture screw improperly adjusted. 10. Accelerator pump damaged or not working. 11. Water or dirt in the fuel ...
Usually answered in minutes!
92 Questions
83 Questions
76 Questions
62 Questions
10 Questions