hot, use a VtVm to loop through the extension cord to each wire in main breaker box (top and bottom of each line/switch) and the bundle of wires in stove/oven box, testing continuity on each one. This
rod(s) and hood of the spark ignition. If it is a Hot Surface Igniter (glow coil) look on the opposite end of the burners and you will see a rod protruding in to the flame. It's called a flame sensor.
...hot surface ignitor that has two wires). you want the part that has only one wire connected to the sensor under the buner. pull it out and sand the dirt off of the metal rod. reinstall and enjoy your ...
...hot rodding a 51 ford, and need to know engine wiring for ignition of a 82 351 cleveland) to get spark) It's got a distributor, and a 2 and 4 wire connector off the ignition module. I worked at the ...
Question about Hot Rod Deluxe Guitar Combo Amplifier
...hot rod delux is switching channels automatically. My hot rod delux is switching channels without me pressing anything. I don't have the pedal plugged in and the only way to switch it back to normal ...
...hot power in) WHT to CP4 (neutral power in) RED to CP11 and CP12 (high voltage, probably 280VAC) GRN to CP13 and CP14 (6.6VAC filament power) BRN to CP15 and CP16 (about 38VAC bias supply) If you ...
...hot Runs good when it run, but shut it off and it wont start. I have put in a new set of points and condenser. I thought I found the problem when I discovered the rotor would not advance. I got that ...
Question about 1979 XLH 1000 Sportster
...hot, way more stable weld. Problem is the ground lead bites you on ac and dc,both polarities. Checked it with a volt meter and the weld polarity is right. (Also, it did this with the old transformer ...
Question about FEF455BB Electric Kitchen Range
...rod to the lock. Also, in pic 2, follow the troubleshooting steps outlined on the right--most notably the stalled cooling fan, broken safety thermostat(you'll need a voltage/ohm meter and the power ...
Question about FEF455BB Electric Kitchen Range
500 front seat. I took the seat out of a ford and I am putting it into my hot rod 29 model A . I only need the wires that adjust the seat, This is for 05 ford 500. I believe the info said w/o recliner
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions
