Question about 24 in. 16032 Built-in Dishwasher
Kenmore Ultra Wash Dishwasher; Model 665.17539 I have the above model dishwasher, it goes thru the complete cycle but it does not dry the dishes, it does not heat-up. I have a Kenmore 665 about 3 ...
Question about 24 in. 16032 Built-in Dishwasher
start gas dryer heat will ignite after a couple minutes no heat gas dryer heat will ignite after two minutes the heat will shut off and not come back on i replaced pad sensor, i also cleaned out all ...
Microwave won't heat up while in use While I was cooking, I used a towel to wipe soil off the touch pad on the front of the microwave. Since I did that, the microwave won't heat up. I love this ...
the fan start coming on after the oven is heated up then f10 starts flashing and the oven starts beeping on my kenmore elite convection oven the only codes ifind for the f 10 is defective touch pad.. ...
Question about 40494 / 40495 / 40499 Electric Single Oven
I have a Kenmore Wall electric oven unit that the heat element at the top is working only and F2 is what comes up and continues to beep. The heat is extreme. WE are wondering if we should just get a ...
While using the oven, a code EO-F2- appeared and would no longe heat. F2 - E0 Shorted keypad (also called touch pad) 1. Check keypad connector for firm connection (keypad connects to control board). 2
My Kenmore 665 has the pots/pans, hi temp and heated dry lights on. It won't cancel or start. Is there a reset button, or what would be the problem? This means the touch pad has failed, You would need
No heat dry light keeps flashing & it will not start to wash the dishes Hello, This means one of two things. The touch pad has failed or the touch pad is locked. Hold down the heated dry button ...
Kenmore quiet guard dishwasher - all buttons except the start button are working. When the start button is pressed the light does not come on and neither does the dishwasher. Try pressing heated dry ...
Question about 24 in. 17032 Built-in Dishwasher
...heating element, but it still will not run. Tested the bi-metal switch, its good. Any suggestions on the next thing to try? The strat pad is probably the problem I have changed control boards and ...
Usually answered in minutes!
485 Questions
214 Questions
206 Questions
161 Questions
175 Questions