Questions & Answers for: gear selector

Help... I need to replace the light on the gear selector instrument. Where do I start, or should I? No bulb replacement for gear selector, gear selector and cluster one part.

...gear selector cable. With engine off, remove engine air intake and air filter box, look for lever on top of transmission, remove nut to disconnect cable. Install wheel chocks, set emergency brake, ...

...gear selector is in the item 25 these are 2 plastic bushings that wear out and cause the gear selector feels loose, you should also check the item 27 this item has one or two screws loose and cause ...

gear selector shaft replacement I think the spline on the gear selector rod / shaft has sheered off (on the inside). I was just able to get the bike back into natural but there is lots of movement. ...

...gear shift selector is cracked & burned .How to remove the automatic shift console on a 1998 Infiniti Q45? you need a haynes repair manual with photos show you how to remove shifter knob ...

...gear are on the same selector rail and if you cannot move the gear lever across the slot that means that the selector rail has not been correctly positioned and the interlocking pin between the rails ...

...rail. It is possible that the selector fork has come loose for the 5th gear or reverse. Remove the gear lever turret section of the box and see if the selector rail is moving gears or the rail

...gear selector tension. Where and how does the gear selector connect to the cable? What is wrong here? Removed belt guard. Belt is intact and in place. It seems like the gear selector should attach to ...

...a selector rail pull the gear lever turret of the top of the box, move the selector rails until they all line up as a slot across all of them , then put the gear lever end back in that neutral ...

...gear selector? The bus starts good it doesn't select gear because of the wrench sign on the gear selector display. You need to connect a scan tool and read the codes. ...