Questions & Answers for: Chevrolet Blazer gas gauge not working

...gauge is almost working backwards when i am low on gas it it reads full when i put even a little bit of gas in it it goes towards the empty mark can you help me?? The mechanic should adjust the the ...

Gas gauge on 95 Buick Roadmaster needs changed possibly. Works full tank to 7/8 - 1/4. Easy to change? this is not the gas gauge, this problem is caused by the gas gauge sending unit inside the gas ...

...gas gauge. It moves back and forth between half a tank of gas and then it shows empty and I put gas in all the time. It seems like the gas gets stuck at some point and I have run out of gas quite ...

...gauge registers empty with a full tank of gas on my 2001 chevy S10 Blazer, we replaced the fuel pump, sending unit. The new pump and sending unit came with a new wiring plug. We made sure we wired it ...

...gas gauge stop working and It's not getting enough gas to the carbeurater sprayed starter fluid and it starts up the high beam not working it just seems like a shortage somewhere with that but ...

...did not work Someone will need to check the circuit at the gas tank, the sending unit next to the pump grounds the gauge on the dash. You should have a voltage reference at the tank from the

...gas gage which one in th diagram is? this is not a separate fuse. for gauge is gauge fuse. but fuel gauge not working could be gauge in tank for level. if you ground purple wire to ground .. fuel ...

gas gauge does not work properly. The gas gauge stay's on FULL at all times no matter how much gas is in it. When it get's low on fuel the gas gauge start's to jump back and forth from F to E and when

GAS GAUGE FUSE it is a bad fuel pump. if the gauge does not work or you can not hear it turn on. it will be a bad pump. also check the ground wire in the wire harness going to the pump, i had those go

...the gas hand will not work have put a new fuel pump on a 1989 chevy blazer and can't get the fuel gauge to work have taken the tank off twice bad body ground at tank connection, also check gauge ...