Questions & Answers for: Oldsmobile Silhouette fuel pump power

Fuel Pump on a 1999 Oldsmobile Silhouette Van V6 3.4L? Is there a Relay on this model as well? Where can I get DIY instructions? Thank you in advance your Assistance! All you may have to do to confirm

...fuel pump getting spark, replaced the fuel pump. not getting any power to the fuel pump,replaced the fuel pump relay and still no power to the pump. I have a silhouette and it had the same problem ...

...fuel pump when you first turn the ignition to the "run" position. You should be able to hear the fuel pump cut in for 2 or 3 seconds. If you don't hear anything, check for power to the fuel pump. If ...

...fuel pump, fuel infector, fuel filter, or fuel pump relay? You mean it cranks but wont start (cranking and turning over are the same thing) When cranking, rap on the fuel tank, if it then runs, the ...

pump. Torque the bolts to 25 ft. lbs. (34 Nm). Fuel pressure test port cap to the fuel rail Power steering pipes to the retainer. Torque the fastener to 54 inch lbs. (6 Nm). Alternator bracket. Torque

...fuel pump? You could very well have a pump that is weak and loses some of it's pumping power after it has gotten fully warmed up. Have you ever noticed a temporary improvement in power after refiling ...

fuel pump on olds silhouette new fuel relay should fix the problem, if not then you have a bigger problem like an ECU, and yes you can have a bad ECU and it will still give it spark, although it could

fuel pump not working need location of circut breaker The fuel pump is powered by a relay and a fuse.  No circuit breakers.The relay and fuse should be in the fuse box in the engine compartment.

...fuel pump When you turn the key on, you should get power to the pump for 3 seconds from the pump relay. If not, check the power from the relay back to the key switch. No power to the starter could be ...

...fuel pump on 92 olds silhoutte i replaced the fuel pump after i found i had to fuel pressure. checked for pressure after replacing the fuel pump. still no pressure. i checked the relay and the fuses ...